2018 Bmw X3 Engine Problems

Your engine's oil pump may fail prematurely because it contains plastic parts that become brittle over time. This is a known issue affecting multiple owners of this vehicle model. When the oil pump fails, your engine won't receive proper lubrication, which can cause severe engine damage. The repair will require replacing the oil pump assembly and possibly flushing the engine oil system.

Your car's oil filter housing was not properly constructed at the factory and is failing. BMW has acknowledged this is affecting multiple vehicles of this model. You may notice oil leaks or warning lights related to oil pressure, and the housing will need to be replaced to prevent engine damage.

Your engine lost coolant and triggered an overheating warning that forced you to pull over. The problem was traced to a leaking oil filter housing, which shouldn't fail this early in the vehicle's life. This left you stranded far from home in winter conditions.

Your engine is leaking coolant from multiple sources — the oil filter housing and water pump. You may notice coolant leaking while driving, and if enough coolant escapes, your engine could overheat and leave you stranded. The fix will likely involve replacing the leaking gaskets, seals, or the water pump itself.

Your coolant warning light came on, indicating low coolant levels in your engine. You discovered the car was leaking coolant slowly, and even after refilling it, the level kept dropping. Your mechanic found that the oil filter housing gasket was failing and needed to be replaced to stop the leak.

Your PCV valve (a part that manages engine ventilation) is failing. You purchased your car as certified pre-owned in 2020, and you're experiencing the same issue that was recalled in 2018 BMW X3 M40 models. This should be inspected and likely replaced by a mechanic to prevent further engine problems.

Your car's coolant system uses plastic pipes that can become brittle and crack over time, which can cause the entire coolant system to fail and potentially damage the engine. This is a known issue at BMW repair facilities. If you notice coolant leaks, overheating, or a sweet smell near the engine, have it inspected immediately. The fix typically involves replacing the plastic coolant pipes with new ones.

Your BMW dealership has told you that the motor mounts need to be replaced, even though your vehicle has fewer than 29,000 miles and these parts typically last 60,000 to 100,000 miles. Since the mounts are failing well before their expected lifespan with no warning signs or dashboard indicators, this suggests a manufacturing defect or installation error from the factory. You may notice this is a known issue affecting 2018-2020 X3 models. Fixing this will involve removing and replacing the engine motor mounts.

The contact owns a 2018 BMW X3. The contact stated while driving approximately 55 MPH, the "Engine Coolant Level Low" and "Engine Overheating" warning lights illuminated. The contact drove the vehicle to an Auto Parts store and purchased a gallon of coolant. The contact refilled the coolant reservoir and became aware of a puddle of coolant underneath the vehicle. The contact drove the vehicle to a local dealer. The vehicle was not yet diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 71,000.

The contact owns a 2018 BMW X3. The contact stated that while driving on the highway at 48 MPH, the temperature gauge indicated that the engine was hot, and the “Warning – Pull Over - Engine Overheating” was displayed. The contact pulled over to the side of the road to allow the engine to cool down. The contact restarted the vehicle however, the message that the engine was overheating was again displayed. The vehicle was towed to the residence. The contact stated that several days later the vehicle was towed to a local dealer to be diagnosed. The contact was informed that coolant was leaking from the bottom of the reservoir, and that the coolant feed lines, return lines, O-rings, coolant pump, connectors, seal for the intake system, and the oil filter housing component system needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 89,000.

The contact owns a 2017 BMW X3. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated while driving approximately 65 MPH, the vehicle lost motive power. The contact observed that the temperature warning light was illuminated. The contact pulled over and waited more than 30 minutes for the engine to cool down and was able to restart the vehicle. The contact had to stop again when the engine temperature warning light illuminated. The contact had taken the vehicle to an independent mechanic who diagnosed that the water pump needed to be replaced. The vehicle was not repaired. Additionally, the contact stated that there was an electrical failure with the windows lowering independently, and the door locks locking and unlocking independently. The contact stated that the heater was no longer functioning as designed. The failure mileage was approximately 139,000. VIN tool confirms parts not available.

The contact owns a 2018 BMW X3. The contact stated while his wife was driving 65 MPH, a message advising to stop driving was displayed, and the vehicle simultaneously shifted into neutral(N) independently. The vehicle stalled in the middle of the highway and failed to respond while depressing the accelerator pedal. The message advising to drive with caution was displayed after several minutes, and the contact was able to continue driving upon depressing the accelerator pedal. The vehicle was taken to an unknown dealer to be diagnosed. The vehicle was not diagnosed or repaired. The vehicle was then towed to the local dealer, where it was diagnosed that coolant was leaking from a hose. Additionally, the dealer informed the contact that excessive engine temperature could have damaged the cylinder head and the rod bearings. The dealer recommended replacing the engine. The vehicle was not repaired. The contact stated that his son-in-law then towed the vehicle to another facility, where the vehicle was diagnosed by a mechanic; however, no engine failure or coolant leak were found. The contact related the failure to an unknown recall. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 152,942.

The oil filter housing, which is made of plastic, cracked while the vehicle was running on the highway, leading to sudden loss of the all the coolant and engine overheating.

* Components: Per dealership, Heat exchanger (metal) and oil filter housing (plastic), oil filter housing supports the heat exchanger, vehicle inspected by dealership and available for further inspection. *Vehicle unexpectedly overheated while driving on interstate risking the safety of driver/passengers and others. Dealer's (manufacturer) technician stated that the heat from the metal exchanger warped the plastic oil filter housing causing coolant to leak from heat exchanger, thus not allowing coolant to circulate to engine (leaking out) and causing vehicle to overheat. Metal warping (or potentially melting) plastic seems hazardous *Dealer's technician (manufacturer) inspected and identified the problem and quoted a cost of $3,140.80 to repair (this is seemingly a manufacturer's design flaw). Vehicle's warning system displayed an alert that coolant level was low while driving on interstate and recommended adding coolant soon. Driver pulled over within 5 min of warning light and added coolant. Within 5 min of driving away, Vehicle's onboard warning system displayed warning that vehicle coolant was low and engine temperature was elevated but it was safe to drive a low speed and consult nearest dealership, 2 min afterwards, vehicle alerted driver that engine overheated and to stop vehicle and contact nearest dealership. Vehicle towed to nearest dealership.

TL* THE CONTACT OWNS A 2018 BMW X3. THE CONTACT STATED THAT WHILE HER HUSBAND WAS DRIVING AT 80 MPH, THE COOLANT LEVEL LOW, DRIVE AT A MODERATE SPEED WARNING MESSAGE HAD APPEARED ON HER INSTRUMENT PANEL. THE CONTACT'S HUSBAND CONTINUED TO DRIVE AT A MODERATE SPEED AS ADVISED, SOON AFTER, THE PULL OVER, STOP THE CAR WARNING MESSAGE ALSO ILLUMINATED ON THE INSTRUMENT PANEL AND HER HUSBAND PROCEEDED AS ADVISED. DUE TO THE FAILURE, THE CONTACT'S HUSBAND HAD THE VEHICLE TOWED TO THE AUTOMASTER BMW (3328 SHELBURNE RD #3, SHELBURNE, VT 05482). THE DEALER INFORMED THE CONTACT THAT THEY DISCOVERED A COOLANT LEAK AND THAT A PART NEEDED TO BE ORDERED TO REPAIR THE VEHICLE. PRIOR TO THE FAILURE, THE CONTACT STATED THAT THE SAME COOLANT LEVEL WARNING MESSAGE HAD APPEARED ON THE INSTRUMENT PANEL. THE CONTACT HAD TWICE TAKEN THE VEHICLE TO SOUTH SHORE BMW(1040 HINGHAM ST, ROCKLAND, MA 02370) WHERE THEY NEVER DISCOVERED A COOLANT LEAK AND WOULD TOP OFF HER COOLANT LEVELS EACH TIME SHE VISITED THE DEALER FOR THE SAME MATTER. THE DEALER WAS THEN NOTIFIED AGAIN OF THE LATEST FAILURE AND THE CONTACT WAS INFORMED THAT THE FAILURE WAS DUE TO NORMAL VEHICLE OPERATION, THEY OFFERED NO FURTHER ASSISTANCE WITH THE FAILURE. THE VEHICLE REMAINED IN THE POSSESSION OF THE AUTOMASTER BMW(3328 SHELBURNE RD #3, SHELBURNE, VT 05482) AND HAD YET TO BE REPAIRED. THE MANUFACTURER HAD YET TO BE NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 6,000.