2022 Subaru Outback Engine Problems

While driving on the highway, your engine started making a rattling noise and then began to struggle with acceleration until it couldn't accelerate anymore. Your oil pressure warning light came on around the same time, and when you pulled over, you noticed steam and white smoke coming from the front of the engine. The smoke increased and the front of the car caught fire.

While stopped at a yield sign waiting for traffic to clear so I may proceed with my left turn, I stepped on the accelerator pedal to make my left turn; however, my car did not go because the engine had turned off due to the auto stop feature. Once the engine restarted, I was no longer clear about proceeding with my left turn and had to apply the brakes very hard immediately to stop my vehicle. The auto engine stop is a dangerous feature that should not automatically be applied when starting the car.

This is in response to your boilerplate letter of May 25, 2024. That correspondence stated that my 2022 Subaru Outback’s inspection of May 21, 2024, did not reveal any manufacturing defect that caused the unanticipated acceleration of my vehicle on April 26, 2024. That inspection was conducted by a third-party engineering firm. In amplification of this, the following is provided: • My vehicle on 26 April 2024, at approximately at 0845 AM experienced unanticipated acceleration, in my garage where it had been parked overnight. It was a cool morning. This occurred without any direct body movement from me, whatsoever. The fast forward motion I directly experienced in my vehicle was like if one put their gas pedal to the floor. The vehicle crashed about five feet into a garage shelf with me simultaneously providing braking. This directly caused about $3,000 worth of damage to the vehicle, and I will probably incur higher insurance cost because of this. •Environmental factors have been a contributing factor in unanticipated acceleration in the past. •Time to extract the data from the EDR in my vehicle took almost one month for SOA to complete the inspection (accident occurred on April 26 and the vehicle inspection took place on May 21). •Starlink, Subaru’s automatic collision notification system, did not activate on 26 April 2024, the day of the accident. •“As a rule of thumb, if the crash is sufficient to cause the air bags to deploy the EDR data are usually captured.” From the National Highway Transportation Safety Board’s website under, “EDR Q & A). My vehicle’s air bags did not deploy, and another key word is “usually”. •On May 16, 2024, five days before the inspection was completed on my vehicle I wrote the CEO a letter. Part of that letter is quoted, verbatim, for your review: “It is now my understanding, according to SOA, that what happened to me is referred to as unanticipated acceleration. Being a Subaru owner for over ten years, such in inc

Thermal control valve became inoperable at less than 40,000 miles. Engine shut down and began to overheat. Part is known to easily fail by Subaru. Has been examined by dealership. All warning lights came on at once, and cruise control and Eyesight were disabled. NHTSA Recall Number 23V755000 We have been on the list for this recall repair since 12/28/2023, we were told when we scheduled the service appointment for the TCV that the dealership was not doing any more recall repairs any time soon as they could not get parts.

Lower oil pan leaks due to poor QA/QC at the factory so I’m told. And possibly the upper oil pan leaking to. Researched forums and it’s a requiring problem. So is the problem big enough for a recall? One issue is that the dealership didn’t notice it during last inspection and service. Or is the dealership being told to remain silent ? Never less the end user suffers with worrying about if it’s going to happen again and cause bigger issues. Please check forums on this issue. Thank you

This has happened many times since my vehicle ownership in May. Today for example I am on the highway cruising along (cruise control set) and alarms start going off, the vehicle lurches as it self-disables safety features one by one - Cruise control shuts off automatically - check engine light on, reverse auto breaking disabled, lane assist disabled, Collision avoidance disabled, entire eyesight system disabled. (and I'm sure more I am missing) I have contacted Subaru of America many times about this fault, they have yet to respond appropriately to my inquiries (usually they dont respond at all or simply tell me something about the factory stereo?). The only fix I've found is removing the gas cap tapping it a few times and resetting (to the "one-click") tightness. After multiple start/stops the codes will clear and life will resume with safety features. This incident today was 204.3 miles into my gas tank, not sure how the gas cap is related but something is definitely wrong. If it truly is the gas cap they could simply have a small icon on the 11" display vs disabling every safety feature- While I am DRIVING!

The initial incident occurred on July 31, 2021. I used the push button start to start the car, put the vehicle in reverse, and the vehicle proceeded to roll uncontrolled down my driveway, which is on a slope. I had no power steering or power brakes. I was able to safely stop the vehicle with no incident other than damage to the plastic over the right rear taillight. I turned the vehicle off and restarted it, and everything seemed operational. It seemed that the car's engine had not turned on, only the electrical system. The same issue happened repeatedly over the next few days. In observing what was happening, I have noticed that the push button ignition requires a significant press in order for the vehicle to start correctly - quite different from my experience with our previous two push-button start vehicles. In the "Getting Started Guide, Outback 2022", p. 41, instructions clearly state "briefly press and release the Engine START/STOP button." I submit that this is inaccurate, and that new vehicle owners should be advised as to what to do, and what to look for in the dashboard to understand that the vehicle engine has, in fact, started properly. I am a user experience researcher, including in automotive research, and we have an expression that there's no such thing as user error, just poor design. This is a clear example of poor design.